HobbyKing
TURNIGY 480L V-SPEC INRUNNER W/ IMPELLER 1370KV
| Diameter of shaft | 4mm |
| Length of front shaft | 13mm |
| Battery | 4 Cell 4S/14.8V |
| RPM | 1370kv |
| Max current | 60A |
| No load current | 1.0A |
| Internal resistance | 57.10ohm |
| Data | 4S 14.8V |
| Max Current | 17.7A, 19.5A, 25A |
| Pull | 1030g, 1120g, 1300g |
| ESC | 60A |
| Battery Type | 4S Only |
Dimension:, 57mm x 30mm, 70mm(with shaft), Weight:, 143g (kv1500) (not including connectors), Lamination thickness: ., Prop:, APC12x8, APC12x6, APC8x3.8,
High torque inrunner, excellent for running propellers without needing a ...5 Reviews
HobbyKing
TURNIGY G160 BRUSHLESS OUTRUNNER 245KV (160 GLOW)
| Battery | 9~10 Cell /33.3~37V |
| RPM | 245kv |
| Max current | 60A |
| No load current | 10V/1.45A |
| Current capacity | 78A/15sec |
| Internal resistance | 0.03 ohm |
| Diameter of shaft | 8mm |
| Dimensions | 89x64mm |
Weight:, 649g (not including connectors),
Designed to be a direct swap out for your 160 ...5 Reviews
HobbyKing
C2222 MICRO BRUSHLESS OUTRUNNER 2850KV (15G)
| Diameter | 22.2mm |
| Length | 24mm |
| Shaft | 5mm |
| Weight | 15g (with 10cm wire) |
| Power | 60W |
| Resistance | 485 |
| Idle Current | .7A |
| Max amp | 10A (15sec burst) |
| Voltage | 2-4cell Lipoly |
Kv: 2850rpm/v, Turns: 25,
Specifications. We do not have a suggested prop size for ...5 Reviews
HobbyKing
MINI AIR COMPRESSOR (1/8HP) 220-240V
| Type | Piston |
| Power | 1/8HP |
| Max Pressure | 2.8BAR/40PSI |
| Speed/Min | 2900, 220-240V/50HZ |
| Air Flow | 13-15L/Min |
| Dimension(L*W*H) | 18CM*11CM*14.5CM |
| weight | 2.4KGS |
Specifications:, Electric Current:, 0.65A/50HZ;1.4A/50HZ,
Great for small workshops. Low noise and regulated posative airflow ...5 Reviews
HobbyKing
HOBBYKING PARALLEL CHARGING BOARD FOR 6 PACKS 2~6S (XT-60)
| Cell | 2~6S |
| Voltage | 0~22.2VDC |
| Max current | 30A |
| Connector | XT60/jst-xh |
Battery:, 6 packs (same capacity & cell count), Note:, The batteries should have same capacity.,
Our very own in-house designed and built parallel charge board! ...5 Reviews
HobbyKing
TBS MINI PROGRAMMABLE SOUNDUNIT
| Can be fully configured with free PC software | Download from the files Tab below |
| Dimensions | 55x25x10mm |
| Note | Extension wire shown in the photo not included. |
Features:, Fully customer programmable., Technical Spec:, Supplyrange:, 3.5~12V (from receiver), Internal amplifier:, 1.2W at 8 Ohm and 5V supply, Switching outputs:, Minus switching, max. 12V/0.5A each, Weight:6g,
This soundunit is developed specially for electric powered airplanes. And ...5 Reviews
HobbyKing
1/16 BRUSHLESS 4WD MONSTER BEATLE W/ 25AMP SYSTEM
| Motor | Brushless Inrunner(2040) |
| ESC | 25A Brushless (with Reverse) |
| Battery | 2S LiPo (100x40x25mm MAX SIZE) w/ XT-60 connector [Required] |
| Servo | 15g Micro |
| Traction | Full Time 4WD, Twin Diff |
| Length | 280mm |
| Width | 210mm |
| Height | 150mm |
| Groung Clearance | 20~40mm Adjustable |
| Top Speed | 40km/h on standard System |
5 Reviews
HobbyKing
TURNIGY 4 IN 1 TORX DRIVER 1.4~ 2.7
| Head | Torx (hexalobular) AKA Star Bit |
5 Reviews
HobbyKing
TURNIGY TRUST 70A SBEC BRUSHLESS SPEED CONTROLLER
| Brake | off |
| Battery | LiPo Auto Detect |
| Low Voltage | 3.2v (power down motor) |
| Max Motor Current | 70A |
| BEC Voltage | 5.5v (Switching) |
| LiPo | 2~6S |
| NiMH | 5~16cells |
| Weight | 65grams |
Max BEC Current: 3A,
Turnigy® TRUST SBEC ESCs have a very flexible and broadly ...5 Reviews
HobbyKing
NTM PROP DRIVE SERIES 35-36B 1400KV / 495W
| Model | NTM Prop Drive 35-36B 1400 |
| Max current | 53.94A |
| Shaft | 4mm |
| Weight | 117g |
| ESC | 60A |
| Cell count | 3s~4s Lipoly |
| Bolt holes | 18.9mm & 25mm |
Specs:, Model:, Kv:1400rpm/v, Turns:7, Max Power:, 495W @ 12v (3S) / Waiting test results (4S), Bolt thread:M3, Suggested Prop:, Prop test data coming soon!,
NTM Prop Drive motors are rock-solid performance outrunners with tight ...5 Reviews
HobbyKing
HOBBYKING XP 3A 1S 0.7G BRUSHLESS SPEED CONTROLLER
| Max Voltage | 4.2v |
| BEC | Not required. power supplied directly from 1S battery. |
| Programable | Yes |
| Weight | 0.7g |
| Dimensions | 11x13x8mm |
Cont. Current: 3A, Burst Current: 4A,
HobbyKing XP 3A 1S 0.7g Brushless Speed Controller The HK ...5 Reviews
HobbyKing
TURNIGY 540S V-SPEC INRUNNER W/ IMPELLER 1350KV
| Diameter of shaft | 5mm |
| Length of front shaft | 13mm |
| Battery | 3-4 Cell 4S/14.8V |
| RPM | 1350kv |
| Max current | 40A |
| No load current | 2.1A |
| Internal resistance | 75.2ohm |
| Data | 3S 11.1V |
| Prop | APC7x4, APC10x4.7 |
| Max Current | 16.6A, 37A |
| Pull | 720g, 1260g |
| Prop | APC7x4 |
| Max Current | 29A |
| Pull | 1100g |
| ESC | 60A |
| Battery Type | 3-4S Only |
Dimension:, 52mm x 36mm, 66mm(with shaft), Weight:, 141g (kv1350) (not including connectors), Lamination thickness: .,
High torque inrunner, excellent for running propellers without needing a ...5 Reviews
HobbyKing
TURNIGY T600 BRUSHLESS OUTRUNNER FOR 600 HELI (1100KV)
| Weight | 369g |
| Turns | 10T |
| Voltage | 5~7S |
| Max Current | 110A |
| Diameter of shaft | 6mm |
| Length of front shaft | 21.5mm |
| ESC | 100~120A |
Specifications:, Dimension:, 58mm x 49mm, 78mm(with shaft), Kv:1100rpm/V,
Is your 600 heli ready for the next level in ...5 Reviews
HobbyKing
TURNIGY 450 H2218 BRUSHLESS OUTRUNNER 3550KV
| Model | 2218 |
| Turns | 3.5 |
| Cells | 2~3S |
| No load Current | 4.7A/10V |
| Max power | 500W |
| Weight | 67g |
| Dimensions | 27.2 x 36.5mm |
| Recomended ESC | 2~3S/30A |
Kv: 3550rpm/V,
This motor is specifically designed for the 450 helicopter range ...5 Reviews
HobbyKing
TURNIGY 450 H2218 BRUSHLESS OUTRUNNER 1860KV
| Model | 2218 |
| Cells | 2~4S |
| No load Current | 1A/10V |
| Max power | 500W |
| Weight | 67g |
| Shaft diameter | 3.17mm |
| Dimensions | 27.2 x 36.5mm |
| Recomended ESC | 2~4S/50A |
Turns: 5, Kv: 1860rpm/V,
This motor is specifically designed for the 450 helicopter range ...5 Reviews